Influence of size effect on springback and thickness distribution of hydroformed ultra-thin metallic bellows
2238-7854
Abstract
Ultra-thin metallic bellows are critical components in new energy vehicles and aerospace applications, yet their forming precision is significantly challenged by size effects when the wall thickness is reduced to the mesoscopic scale. This study systematically investigated the size effect in 304 stainless steel ultra-thin-walled bellows through uniaxial tensile tests, V-bending tests, and hydroforming experiments, complemented by EBSD characterization. As the thickness-to-grain-size ratio ( t / d ) decreased from 11.0 to 4.9, a pronounced size-dependent softening effect was observed: yield strength dropped from 336 to 286 MPa, and elongation from 33.7% to 9.8%. EBSD analysis quantitatively established the underlying micro-mechanisms. The mean KAM value decreased from 0.32° to 0.10°, indicating reduced dislocation storage capacity. GOS distributions broadened with grain coarsening, evidencing intensified strain localization. The fraction of grains with high Schmid factors increased, promoting preferential slip. The bending springback angle diminished from 13.1° to 5.2° as t / d decreased from 11.0 to 4.9. For hydroformed bellows, the convolution height increased by 3.04%, while the crest thinning ratio rose from 18.0% to 22.7% and the root thinning ratio from 3.3% to 4.7%. A modified constitutive model incorporating a thickness-dependent softening term was developed and validated. These findings provide a critical theoretical basis and experimental support for optimizing the precision forming of ultra-thin-walled metallic bellows.