Design and electrochemical evaluation of a CuNWs/rGO/PEDOT:PSS multilayer counter electrode for DSSC

Journal: Next Materials • • Elsevier • ISSN: 2949-8228

Abstract

Dye-sensitized solar cells (DSSCs) require an efficient and cost-effective counter electrode to replace the conventional platinum counter electrode, whose scarcity, high cost, and fabrication complexity hinder large-scale commercialization. A multilayer counter electrode was fabricated through the sequential deposition of copper nanowires (CuNWs), reduced graphene oxide (rGO), and poly(3,4-ethylenedioxythiophene)-poly (styrene sulfonate) (PEDOT:PSS), and its suitability as a Pt-free counter electrode was investigated. The novelty of the present study lies in the sequential engineering of the counter electrode by rationally integrating conductive CuNWs, rGO, and PEDOT:PSS into a multilayer architecture. Structural and morphological analyses confirmed the formation of a highly interconnected network of CuNWs that provided low-resistance pathways for electron transport, while the incorporation of rGO enhanced electrical conductivity and provided additional catalytic sites; the PEDOT:PSS layer further improved the electrocatalytic activity and increased structural stability and interfacial contact with the device. The synergistic contribution of these components to the improved performance of the CuNWs/rGO/PEDOT:PSS counter electrode was confirmed by characterisations of the individual materials and binary combinations. Electrochemical studies revealed low series resistance and favourable charge-transfer kinetics, making the CuNWs/rGO/PEDOT:PSS counter electrode comparable to Pt in electrocatalytic performance. Photovoltaic measurements showed that the CuNWs/rGO/PEDOT:PSS-based DSSC achieved a power conversion efficiency of 9.52 ± 0.15%, with a short-circuit current density of 22.43 ± 0.39 mA/cm², an open-circuit voltage of 0.69 ± 0.004 V, and a fill factor of 61.51 ± 0.64%, which is on par with a conventional DSSC employing a Pt counter electrode. These results highlight the suitability of the CuNWs/rGO/PEDOT:PSS counter electrode as a promising, efficient, economical, and scalable alternative to Pt for DSSC applications.

Subjects & Keywords

How to Cite this Article

T.S. Dhanusree, George Jacob (2026). "Design and electrochemical evaluation of a CuNWs/rGO/PEDOT:PSS multilayer counter electrode for DSSC". Next Materials. https://doi.org/10.1016/j.nxmate.2026.103748