Home »
Academic Articles »
C »
Heat transfer augmentation of Al2O3-Cu/water hybrid nanofluid in circular duct with inserts
Heat transfer augmentation of Al2O3-Cu/water hybrid nanofluid in circular duct with inserts
Muluken Biadgelegn Wollele
(School of Mechanical and Industrial Engineering, Institute of Technology, Debre Markos University, Debre Markos, Ethiopia)
Harish H.V
(School of Mechanical and Industrial Engineering, Institute of Technology, Debre Markos University, Debre Markos, Ethiopia)
Mebratu Assaye
(School of Mechanical and Industrial Engineering, Institute of Technology, Debre Markos University, Debre Markos, Ethiopia)
Journal: Cogent Engineering
•
• Taylor & Francis Group
• ISSN: 2331-1916
Abstract
Nanotechnology has opened up new avenues for industrial efficiency and performance. The Al2O3-Cu/water hybrid nanofluid with and without insert is analyzed numerically and validated to show heat transfer enhancement. A circular duct with inserts, a tube length of 3 m, a hydraulic diameter of 0.01 m, tube wall with a constant heat flux of 20 kW/m2, and a twist ratio of 125 were used to examine Al2O3-Cu/water hybrid nanofluid in turbulent regime. At Re = 20,000, due to insertion of twisted tape, there is an additional mixing of fluid that takes place, leading towards increase in temperature of around 1–1.75% when compared with that of without inserts. The Nusselt number is improved for plain twisted tape tube by 1.5–2.0% higher than plain tube as revealed in the result. Moreover, there is a 1.01 times improvement in performance evaluation criteria when twisted tape is inserted instead of plain tube.