Home »
Academic Articles »
C »
3D printing technology in the management of carpal tunnel syndrome: A case report
3D printing technology in the management of carpal tunnel syndrome: A case report
Md. Israt Hasan
(Department of Physical Medicine and Rehabilitation, Kurmitola General Hospital, Dhaka, Bangladesh)
Masrufa Tasnim
(Department of Robotics and Mechatronics Engineering, University of Dhaka, Dhaka, Bangladesh)
Syed Mozaffar Ahmed
(Department of Physical Medicine and Rehabilitation, Bangabandhu Sheikh Mujib Medical University, Dhaka, Bangladesh)
Taufiq Morshed
(Department of Orthopedic Surgery, Kurmitola General Hospital, Dhaka, Bangladesh)
Shamim Ahmed Deowan
(Department of Robotics and Mechatronics Engineering, University of Dhaka, Dhaka, Bangladesh)
Journal: Bangabandhu Sheikh Mujib Medical University Journal
•
• Bangabandhu Sheikh Mujib Medical University
• ISSN: 2074-2908
Abstract
A 35-year-old individual with carpal tunnel syndrome presented with tingling and numbness in the left thumb, index, and middle finger. A 3D printed CTS splint was crafted to immobilize the affected wrist joint, aiding pharmacotherapy. At six weeks, evaluations included the Boston Carpal Tunnel Questionnaire (BCTQ), Visual Analogue Scale (VAS) for pain, and Evaluation of Satisfaction with assistive Technology (QUEST) version 2.0.9. Substantial improvements were observed in Bangla-BCTQ scores (symptom severity scale: 3.68 vs. 1.27; functional status scale: 2.74 vs. 1.31), VAS (70 vs. 30), and QUEST scores. 3D printing technology may contribute to better personalized musculoskeletal care enhancing quality of life.
Md. Israt Hasan, Masrufa Tasnim, Syed Mozaffar Ahmed, et al. (2024). "3D printing technology in the management of carpal tunnel syndrome: A case report". Bangabandhu Sheikh Mujib Medical University Journal. https://doi.org/10.3329/bsmmuj.v17i1.71690