Academic Articles & Research Papers

Masterbatch-enabled acceleration of polyolefin biodegradation under open air terrestrial environmental conditions

Abstract Polyolefins, commonly used in packaging and single-use products, are notoriously persistent in the environment, contributing significantly to environmental pollution. In scientific literature to date, polyolefins have not been repo...

The structural diversity of ibuprofen sustained-release pellets on the same goal of bioequivalence consistency

The consistency evaluation, which is largely unexplored is crucial in regulating the quality and efficacy of generic drugs. In this report, after generic ibuprofen (IBU) sustained-release pellets were developed and validated as bioequivalen...

High‐performance optical noncontact controlling system based on broadband PtTex/Si heterojunction photodetectors for human–machine interaction

Abstract Noncontact interaction systems have attracted considerable research attention in recent years because of convenient operation, sterility, and injury prevention. However, the insufficient sensing distance and weak robustness of nonc...

INFLUENCE OF ACTIVE MODIFICATION PARAMETERS ON BEARING CHARACTERISTICS OF OPPOSITE GEAR PAIRS (MT)

Active gear design is a method that can pre-control gear meshing performance directly. In order to study the influence of active gear design on the bearing characteristics of tooth surface, the relationship between active modification param...

Quantum Physics and Nuclear Engineering

The conference brings together researchers working on mathematical foundations of quantum physics, quantum computing, and related areas, with a focus on structural perspectives and the use of logical tools, ordered algebraic and category-th...

COMPUTATIONAL INTELLIGENCE IN NUCLEAR ENGINEERING

Approaches to several recent issues in the operation of nuclear power plants using computational intelligence are discussed. These issues include 1) noise analysis techniques, 2) on-line monitoring and sensor validation, 3) regularization o...

Sharing tactical data in a network-enabled coalition

The NATO Command, Control and Consultation Agency (NC3A) is a participant in a coalition project called the Shared Tactical Pictures (STP). The aim of STP is to develop methods and techniques to enable the sharing of a wide variety of infor...

A novel generalized sliding mode controller for uncertain robot manipulators based on motion constraints

To improve the trajectory tracking performance and robustness for uncertain robot manipulators, a generalized sliding mode controller (GSMC) including an ideal controller and a continuous sliding mode controller (SMC) is proposed from the s...

Sistema electrónico de control del tomógrafo de transmisión de rayos gamma yTAC-02

Critical thickness of GaN film in controllable stress-induced self-separation for preparing native GaN substrates

Stress-induced self-separation is one of the most efficient process for preparing native GaN substrate. The control of GaN film thickness is the key point for GaN film separating from substrate completely. Considering the bowing of bilayer,...

Research on an Electromagnetic Actuator for Vibration Suppression and Energy Regeneration

This paper proposes an electromagnetic actuator that concurrently realizes two working functions of vibration suppression and energy regeneration. The actuator consists of four permanent magnetic rings, three soft iron rings, three coils, a...

Delay-Dependent H∞ Control for Singular Markovian Jump Systems With Generally Uncertain Transition Rates

This article is devoted to the problem of H control for a class of singular Markovian jump systems with time-varying delay and generally uncertain transition rates, which means each transition rate is completely unknown or only its estimate...

Investigation of particle exhaust from EAST divertor

Particle control is one of the key issues for steady-state tokamak operation. The density decay time is used to evaluate the capability of the divertor to exhaust particle with all fueling turn off. Experiments of the EAST divertor's abilit...

Nuclear Engineering for an Uncertain Future

"Nuclear Engineering for an Uncertain Future." Nuclear Technology, 62(1), p. 124 Additional informationNotes on contributorsJohn M. ChristensonJohn M. Christenson has been a faculty member in the Department of Chemical and Nuclear Engineeri...

Unveiling the Assembly of Neutral Marine Polysaccharides into Electrostatic-Driven Layer-by-Layer Bioassemblies by Chemical Functionalization

Marine-origin polysaccharides, in particular cationic and anionic ones, have been widely explored as building blocks in fully natural or hybrid electrostatic-driven Layer-by-Layer (LbL) assemblies for bioapplications. However, the low chemi...

Test on Increasing Drop Strength of Complex Deoxidizer by Epoxy Resin Binder and Application

According the issue of Al-CaO complex deoxidizer for clean steel easily crushing during process of falling from 10 meters high burden bin led to low utilization, increase of cost and dust pollution in situ, the effect of adding epoxy resin,...

Introduction to Nuclear Engineering

(Most chapters end with References and Problems). 1. Nuclear Engineering. 2. Atomic and Nuclear Physics. Fundamental Particles. Atomic and Nuclear Structure. Atomic and Molecular Weight. Atomic and Nuclear Radii. Mass and Energy. Particle W...

Hidden Markov model based P2P flow identification technique

To identify various P2P flows accurately in real-time,a hidden Markov model(HMM)based P2P flow identification technique was proposed.This approach made use of packet size,inter-arrival time and arrival order to construct flow identification...

Effect of Systematic Control of Pd Thickness and Annealing Temperature on the Fabrication and Evolution of Palladium Nanostructures on Si (111) via the Solid State Dewetting

Abstract Si-based optoelectronic devices embedded with metallic nanoparticles (NPs) have demonstrated the NP shape, size, spacing, and crystallinity dependent on light absorption and emission induced by the localized surface plasmon resonan...

Study on the crystallization kinetics of Ni-Mn-Sn-Fe alloy thin films

This study examines the crystallization kinetics of Ni _50−x Mn _39 Sn _11 Fe _x (x = 0, 0.5, 2, 4 at.%) amorphous thin films prepared by DC magnetron sputtering. SEM and XRD confirm their amorphous structure. Non-isothermal DSC results sho...