Reset
Showing 5 of 5 academic articles

Materials science and engineering

CA (United States) Lawrence Livermore National Lab., D Lesuer, USDOE, Washington, DC (United States) (1997)

During FY-96, work within the Materials Science and Engineering Thrust Area was focused on material modeling. Our motivation for this work is to develop the capability to study the structural response of materials as well as material proces...

OPENALEX Open Access DOI: https://doi.org/10.2172/623044

Investigation of Microstructure and Mechanical Behavior of Nanomodified Cement-Based Materials

Spyridoula G. Farmaki, Dimitrios A. Exarchos, Vasileios Dracopoulos, Anastasios Gkotzamanis et al. • Applied Mechanics (2026)

Recent advances in nanotechnology have highlighted the transformative potential of carbon-based nanomaterials, such as carbon nanofibers, carbon nanotubes, and graphene, in cementitious systems. These materials have shown a remarkable abili...

DOAJ Open Access (DOAJ) DOI: 10.3390/applmech7010013

High temperature Nb-Si alloys using data science: optimization of fracture toughness and high-temperature strength

Chao Xu, Dezhi Chen, Xiaofu Zhang, Qi Wang et al. • Nature Communications (2026)

Abstract High temperature Nb-Si based alloys face a critical challenge: achieving adequate room-temperature fracture toughness ( > 18 MPa·m1/2) for processing while maintaining high-temperature strength, properties that typically compete wi...

DOAJ Open Access (DOAJ) DOI: 10.1038/s41467-026-75353-6

AI-driven data fusion modeling for enhanced prediction of mixed-mode I/III fracture toughness

Anantaya Timtong, Atthaphon Ariyarit, Wanwanut Boongsood, Prasert Aengchuan et al. • Results in Engineering (2024)

This research evaluates the use of artificial intelligence to enhance the accuracy of predictions for mixed-mode I/III fracture toughness in polymethyl methacrylate . Traditionally, assessing fracture toughness relies heavily on destructive...

DOAJ Open Access (DOAJ) DOI: 10.1016/j.rineng.2024.103289