Reset
Showing 20 of 79 academic articles

Application of Electric Field to Developing Falling Films using Wire-Plate Electrode Configuration- An Experimental Study

R. Rouhollahi, S. Baheri Islami, R. Gharraei, M. R. Heirani Nobari • Journal of Applied Fluid Mechanics (2018)

Experimental investigation of Electrohydrodynamic developing falling film flow of transformer oil has been conducted within an inclined rectangular channel and hydrodynamic characteristics of the flow have been revealed. The electric field ...

DOAJ Open Access (DOAJ)

Investigation of a Low-Speed Commutation Voltage Shock Problem in Three-Level ANPC Inverter with Hybrid Modulation Mode

Jian Yu, Renhui Shen, Le Zhou, Zelin Jia et al. • Machines (2023)

With the development of the photovoltaic industry; there will be an increasing demand for efficient, high-power density, and low-cost grid interface converters. Compared with two-level inverters, multilevel inverters have the following adva...

DOAJ Open Access (DOAJ) DOI: 10.3390/machines12010027

Experimental study on start-up and steady-state heat transfer performance of heat pipe with liquid bypass line for accelerating working fluid

Youngmi Baek, Euiguk Jung • Case Studies in Thermal Engineering (2022)

This study investigates the start-up and steady-state heat transfer performance of a heat pipe with a bypass line for accelerating a working fluid. The interface resistance by the counterflow of vapor and liquid under the operation of a hea...

DOAJ Open Access (DOAJ) DOI: 10.1016/j.csite.2021.101708

Alterations in Hip and Knee Joint Contact Force Waveforms and Orientation Induced by Gait Modifications: A Case Study

Laura Rathmair, Willi Koller, Clara Egner, Kevin Kitir et al. • Current Issues in Sport Science (2026)

Introduction & Purpose Idiopathic torsional deformities of lower limb bones can affect a patient’s gait pattern and joint health, while their cause remains unidentified (Koller et al., 2026). Abnormal joint loadings and the progression of ...

DOAJ Open Access (DOAJ) DOI: 10.36950/2026.5ciss011

An Optimal Fourth-Order Finite Difference Scheme for the Helmholtz Equation Based on the Technique of Matched Interface Boundary

Dongsheng Cheng, Jianjun Chen, Guangqing Long • Discrete Dynamics in Nature and Society (2021)

In this paper, a new optimal fourth-order 21-point finite difference scheme is proposed to solve the 2D Helmholtz equation numerically, with the technique of matched interface boundary (MIB) utilized to treat boundary problems. For the appr...

DOAJ Open Access (DOAJ) DOI: 10.1155/2021/2539272

Cyberattacks on Miniature Brain Implants to Disrupt Spontaneous Neural Signaling

Sergio Lopez Bernal, Alberto Huertas Celdran, Lorenzo Fernandez Maimo, Michael Taynnan Barros et al. • IEEE Access (2020)

Brain-Computer Interfaces (BCI) arose as systems that merge computing systems with the human brain to facilitate recording, stimulation, and inhibition of neural activity. Over the years, the development of BCI technologies has shifted towa...

DOAJ Open Access (DOAJ) DOI: 10.1109/ACCESS.2020.3017394

Subsecond optically controlled domain switching in freestanding ferroelectric BaTiO3 membrane

Subhajit Pal, Lan-Tien Hsu, Haoying Sun, Sheng-Han Teng et al. • Nature Communications (2025)

Abstract The quest to develop energy-efficient and fast optoelectronic control of memory devices is essential. In this respect, ferroelectric materials are gaining tremendous importance in information and communication technology. Here, we ...

DOAJ Open Access (DOAJ) DOI: 10.1038/s41467-025-58592-x

Comparative investigation of similar and dissimilar AA6061/AA7075, AA6061/AA2024, and AA6061/AA5083 joints produced by continuous-drive friction welding

Ibrahim Sabry, Abdel-Hamid Ismail Mourad, Mohamed ElWakil • Journal of Materials Research and Technology (2026)

This study considers continuous-drive friction welding to compare AA6061/AA6061, AA6061/AA7075, AA6061/AA2024, and AA6061/AA5083 joints produced under the same nominal processing conditions. Optical and scanning electron microscopy, EDS, XR...

DOAJ Open Access (DOAJ) DOI: 10.1016/j.jmrt.2026.09.145

Evaluation of Natural Extracts as Promising Components of Bioactive Coatings for Orthopedic Implants

Katja Andrina Kravanja, Matjaž Finšgar, Željko Knez, Maša Knez Marevci • Frontiers in Materials (2022)

The development of drug-eluting bioactive coatings for orthopedic implants has gained increased interest in recent years with an intent to reduce postoperative complications and improve tissue regeneration at the implant interface. Due to t...

DOAJ Open Access (DOAJ) DOI: 10.3389/fmats.2022.878176

Recent progress in tailoring Ni-rich layered oxides via coating and doping strategies for enhanced lithium-ion battery performance

Ha Eun Kang, Seong-Do Kim, Young Soo Yoon, Sang-Jin Lee • Applied Surface Science Advances (2025)

Nickel-rich layered oxide cathodes, typified by compositions such as LiNi₁₋ₓ₋ᵧCoₓMnᵧO₂ (NCM) have garnered significant attention as high-energy-density candidates for next-generation lithium-ion batteries. However, their widespread deployme...

DOAJ Open Access (DOAJ) DOI: 10.1016/j.apsadv.2025.100826

Dynamic Assembly of Microgels and Polymers at Non‐Aqueous Liquid/Liquid Interfaces

Xin Guan, Yang Liu, Lianwei Li, Man‐Hin Kwok et al. • Advanced Science (2025)

Abstract Particle assembly at liquid–liquid interfaces presents a promising bottom‐up strategy for creating supramolecular materials with advanced functionalities. However, the significantly lower interfacial tension observed in immiscible ...

DOAJ Open Access (DOAJ) DOI: 10.1002/advs.202415642

Pressure Effects on Monolayer FeCl2: Above‐Room‐Temperature Ferromagnetism with In‐Plane Electric Polarization and Interface‐Free Magnetic Tunnel Junctions

Shubham Tyagi, Paresh C. Rout, Shubham Singh, Udo Schwingenschlögl • Advanced Electronic Materials (2026)

ABSTRACT We investigate the influence of hydrostatic pressure on the physical properties of monolayer FeCl2 for spintronics applications. A phase transition from a ferromagnetic half‐metal to a ferromagnetic semiconductor is unveiled at 4.6...

DOAJ Open Access (DOAJ) DOI: 10.1002/aelm.202500230

Materials science and engineering

• World science report (1996)

a b s t r a c t The dislocation density and the Burgers vector population are determined within the Cu and Nb layers in highly textured sputter-deposited Cu-Nb multilayers by X-ray line profile analysis. The measurements are conducted with ...

OPENALEX DOI: https://doi.org/10.18356/9789210059091c023

Materials science and engineering

CA (United States) Lawrence Livermore National Lab., D Lesuer, USDOE, Washington, DC (United States) (1997)

During FY-96, work within the Materials Science and Engineering Thrust Area was focused on material modeling. Our motivation for this work is to develop the capability to study the structural response of materials as well as material proces...

OPENALEX Open Access DOI: https://doi.org/10.2172/623044

Phase-field models in materials science

Ingo Steinbach • Modelling and Simulation in Materials Science and Engineering (2009)

The phase-field method is reviewed against its historical and theoretical background. Starting from Van der Waals considerations on the structure of interfaces in materials the concept of the phase-field method is developed along historical...

OPENALEX DOI: https://doi.org/10.1088/0965-0393/17/7/073001