Reset
Showing 20 of 33 academic articles

Scalable micro/nanostructured superhydrophobic surface modifications for enhanced energy efficiency and heat transfer performance in stainless steel and titanium

Younghun Shin, Kwon-Yeong Lee, Jeong-Won Lee, Woonbong Hwang • Materials Research Express (2023)

Condensation refers to the change of a substance from a gaseous phase to a liquid phase, an example of which is the condensation of water vapor in nature. Condensation is used in many industries, such as energy generation and seawater desal...

DOAJ Open Access (DOAJ) DOI: 10.1088/2053-1591/ace23a

Experimental study on start-up and steady-state heat transfer performance of heat pipe with liquid bypass line for accelerating working fluid

Youngmi Baek, Euiguk Jung • Case Studies in Thermal Engineering (2022)

This study investigates the start-up and steady-state heat transfer performance of a heat pipe with a bypass line for accelerating a working fluid. The interface resistance by the counterflow of vapor and liquid under the operation of a hea...

DOAJ Open Access (DOAJ) DOI: 10.1016/j.csite.2021.101708

Influence of Non - Condensable Gases on the Processes of Heat and Mass Transfer during Film Condensation of Steam in Heat Exchangers

Reshetnikov I.F., Shikhalev S.V., Tikhonov S.L. • Problems of the Regional Energetics (2018)

The aim of the article is a quantitative assessment of the influence of non-condensable gases on the intensity of heat and mass transfer processes during film condensation of steam in the specific conditions for heat exchanger. The task is ...

DOAJ Open Access (DOAJ) DOI: 10.5281/zenodo.2222362

Heat transfer augmentation of Al2O3-Cu/water hybrid nanofluid in circular duct with inserts

Muluken Biadgelegn Wollele, Harish H.V, Mebratu Assaye • Cogent Engineering (2022)

Nanotechnology has opened up new avenues for industrial efficiency and performance. The Al2O3-Cu/water hybrid nanofluid with and without insert is analyzed numerically and validated to show heat transfer enhancement. A circular duct with in...

DOAJ Open Access (DOAJ) DOI: 10.1080/23311916.2022.2146627

The effect of freeze-thaw cycles on the frost resistance of energy tunnels in cold regions

Yue Guo, Chenglong Wang, Abdelmalek Bouazza, Xuanming Ding et al. • Case Studies in Thermal Engineering (2026)

Seasonal temperature fluctuations in cold regions induce freeze–thaw cycles that can significantly impact the structural safety and maintenance of tunnels. This study uses the Daban Mountain Tunnel as a case study to develop a full-scale nu...

DOAJ Open Access (DOAJ) DOI: 10.1016/j.csite.2026.108518

Design, manufacturing, and performance evaluation of heat pipe with three-segmented composite wick structure

Jiu Yu, Yubo Hu, Yaoxing Peng • Case Studies in Thermal Engineering (2026)

The wick structure functions as a core component for heat pipe (HP) and stands as one of the critical factors that dictate the performance of HP. Consequently, this paper puts forward an three-segmented composite wick structure, which is ma...

DOAJ Open Access (DOAJ) DOI: 10.1016/j.csite.2026.107724

Research progress in high thermal conductivity of silicon carbide matrix composites reinforced with fibers

CHEN Qiang, LI Shun, ZHU Li'an, BAI Shuxin et al. • Cailiao gongcheng (2023)

As one kind of advanced high temperature structural and functional materials, it is necessary for fiber reinforced silicon carbide matrix composites (SiC CMCs) in the field of thermal management (TM) to combine the efficient heat transfer a...

DOAJ Open Access (DOAJ) DOI: 10.11868/j.issn.1001-4381.2023.000079

Lie similarity analysis of MHD Casson fluid flow with heat source and variable viscosity over a porous stretching sheet

Thenmozhi D, M. Eswara Rao, Ch. Nagalakshmi, RLV.Renuka Devi et al. • International Journal of Thermofluids (2024)

The current study presents a novel examination of heat transfer properties in a magnetohydrodynamic (MHD) flow of Casson fluid across a porous stretching sheet, uniquely incorporating the effects of heat source and variable viscosity. Unlik...

DOAJ Open Access (DOAJ) DOI: 10.1016/j.ijft.2024.100804

Heat transfer by three types of hot pack and its implication on the flexibility of the lower back: a randomized, controlled trial

Paulina Fuentes-León, Natalia Jara-Poblete, Pía Bastías-Sánchez, Kaio Fernando Vitzel et al. • Fisioterapia e Pesquisa (2016)

ABSTRACT The use of hot pack is a common superficial thermotherapy strategy and one of its benefits is the increase of muscle flexibility. However, there is a lack of information about the effects of the heat pack alone, without being used ...

DOAJ Open Access (DOAJ) DOI: 10.1590/1809-2950/15088923022016

Experimental investigation on phase change behavior of nanocomposite phase change material filled inside the shell and tube heat exchanger

Ayyappan M, Muthiah A • Materials Research Express (2026)

In this paper, melting and solidification characteristics of composite PCM filled inside the shell and tube heat exchanger were investigated experimentally. ZnO nanoparticles (NPs) were synthesized using the sol–gel method. Myristic acid (M...

DOAJ Open Access (DOAJ) DOI: 10.1088/2053-1591/ae44e7

Nuclear Engineering Handbook

• CRC Press eBooks (2009)

Section I Introduction: Nuclear Power Reactors * Historical Development of Nuclear Power Kenneth D. Kok * Pressurized Water Reactors Richard Schreiber * Boiling Water Reactors Kevin Theriault * Heavy Water Reactors Alistar I. Miller, John L...

OPENALEX DOI: https://doi.org/10.1201/9781420053913

Introduction to Nuclear Engineering

John R. Lamarsh, Edward Melkonian • Physics Today (1977)

(Most chapters end with References and Problems). 1. Nuclear Engineering. 2. Atomic and Nuclear Physics. Fundamental Particles. Atomic and Nuclear Structure. Atomic and Molecular Weight. Atomic and Nuclear Radii. Mass and Energy. Particle W...

OPENALEX DOI: https://doi.org/10.1063/1.3037597

A case study on morphological aspects of distinct magnetized 3D hybrid nanoparticles on fluid flow between two orthogonal rotating disks: An application of thermal energy systems

Zahra Abdelmalek, M. Zubair Akbar Qureshi, S. Bilal, Qadeer Raza et al. • Case Studies in Thermal Engineering (2021)

The consolidation power of different nanomaterials such as metallic nanoparticles and metallic-oxides nanoparticles in a new-fangled and energetic hybrid material should give rise to fascinating properties that combine the advantages of eac...

DOAJ Open Access (DOAJ) DOI: 10.1016/j.csite.2020.100744

Conjugate mixed convection heat transfer with internal heat generation in a lid-driven enclosure with spinning solid cylinder

Md. Jisan Mahmud, Ahmed Imtiaz Rais, Md. Rakib Hossain, Sumon Saha • Heliyon (2022)

The current study investigates conjugate mixed convection heat transmission with internal heat generation in a square enclosure driven by a sliding lid and a solid cylinder with a heat-conducting surface at its center. The enclosure has a s...

DOAJ Open Access (DOAJ) DOI: 10.1016/j.heliyon.2022.e11968

An assessment of the mathematical model for estimating of entropy optimized viscous fluid flow towards a rotating cone surface

Yong-Min Li, M. Ijaz Khan, Sohail A. Khan, Sami Ullah Khan et al. • Scientific Reports (2021)

Abstract Entropy optimization in convective viscous fluids flow due to a rotating cone is explored. Heat expression with heat source/sink and dissipation is considered. Irreversibility with binary chemical reaction is also deliberated. Nonl...

DOAJ Open Access (DOAJ) DOI: 10.1038/s41598-021-89739-7

CFD Simulation of the Slot Jet Impingement Heat Transfer Process and Application to a Temperature Control System for Galvanizing Line of Metal Band

Stefano Cademartori, Carlo Cravero, Martino Marini, Davide Marsano • Applied Sciences (2021)

A CFD model to simulate the cooling technique trough slot jet impingement has been developed. Such a technique has been tested on an existing vertical galvanizing industrial line, which initially envisaged a round jet configuration, the sub...

DOAJ Open Access (DOAJ) DOI: 10.3390/app11031149

Air distribution to reduce nitrogen oxide emissions in the furnace of a boiler with tangential combustion scheme

Andrey V. Gil, Kirill I. Maltsev, Nikita V. Abramov, Stanislav A. Puzyrev et al. • Известия Томского политехнического университета: Инжиниринг георесурсов (2024)

Relevance. Determined by the importance of analyzing the combustion characteristics and factors affecting the emission of nitrogen oxides (NOx) in the furnace chamber of pulverized coal-fired power boiler unit when installing tertiary air n...

DOAJ Open Access (DOAJ) DOI: 10.18799/24131830/2024/12/4883

Series Solution for Steady Three-Dimensional Flow due to Spraying on Inclined Spinning Disk by Homotopy Perturbation Method

Saeed Dinarvand • Journal of Applied Mathematics (2012)

The steady three-dimensional flow of condensation or spraying on inclined spinning disk is studied analytically. The governing nonlinear equations and their associated boundary conditions are transformed into the system of nonlinear ordinar...

DOAJ Open Access (DOAJ) DOI: 10.1155/2012/634102

Solar heat transport analysis of Falkner Skan Casson ternary hybrid nanoparticles over a permeable wedge

Khan Mohsin, Sheheryar Shah, Amra Al Kenany, Meshal Shutaywi et al. • Discover Nano (2026)

Abstract In the modern era, energy has become a vital concern across all sectors, while efficient energy generation remains a significant challenge for scientists and engineers. To overcome this issue, researchers have developed ternary hyb...

DOAJ Open Access (DOAJ) DOI: 10.1186/s11671-026-04821-1