๐Ÿ“–
Comparison of different designs of bottom linings with dry joints
Alain Gasser, Amna Rekik, Eric Blond, K. Andreev

Comparison of different designs of bottom linings with dry joints

Science & Mathematics Published 2011 Verification Pending

Overview & Synopsis

Many bottom linings of refractory structures used in steel making industry are made of masonries with or without mortar. Several designs are possible: parallel, fish bone or radial. To compare the influence of these designs on the maximum stresses in the steel shell, the masonry with dry joints was modelled by a homogeneous equivalent material that takes into account the possibility of joint closure. The thermo-mechanical properties of this equivalent material were determined using a periodic homogenization method. They depend on the joint states (open or closed in the two directions). The use of this equivalent material for the bottom lining of a steel ladle has shown that the design that minimizes the stresses in the steel shell is the radial design.

Indexed from repository: HAL Open Science (hal.science)
Loading document from verified source...
Keyboard Shortcuts: ← / → for pages • + / - for zoom • 0 to fit width Powered by Mozilla PDF.js v3.11

Document Information

Document Title Comparison of different designs of bottom linings with dry joints
Author / Organization Alain Gasser, Amna Rekik, Eric Blond, K. Andreev
Subject & Discipline Multidisciplinary Academic Open Research
Categories Science & Mathematics
Publication Year 2011
License / Rights Open Access / Creative Commons
Resource Verification Listed PDF (Verification Pending)
Original Host Website HAL Open Science (hal.science)
File Format application/pdf (Portable Document Format)
Language EN
Catalog ID DOC-217510
Original Source Link Visit Source Page on hal.science »