Discrimination of coated carbide tools wear by the features extracted from parallel force and noise level
Overview & Synopsis
Coated carbide tools were tested for turning of wood-chip cement board. Coating materials, which were synthesized on the P30 carbide substrate, are titanium carbonitride, titanium nitride, chromium nitride, and titanium nitride/aluminum nitride. Cutting tests were performed at cutting speeds of 30, 40, 50 and 60 m/s, depth of cut of 1 mm, and feed of 0.05 mm/rev. Wear, parallel force and noise level were measured at every specified cutting length. The purpose was to discriminate various stages of wear of the coated carbide tools by the features extracted from parallel force and noise level. The results of the study show that both the parallel force and noise level generated by the tools tested were observed to increase linearly with increasing the tools wear, and would be good parameters for monitoring the tool wear. The parallel force and the noise level of the cutting tools also increased with increasing the cutting speeds for every specified cutting length. The parallel force became more sensitive than the noise level for monitoring the tool wear when the cutting speed was increased.
hal.science)
← / → for pages • + / - for zoom • 0 to fit width
Powered by Mozilla PDF.js v3.11
Document Information
| Document Title | Discrimination of coated carbide tools wear by the features extracted from parallel force and noise level |
|---|---|
| Author / Organization | Wayan Darmawan, Chiaki Tanaka |
| Subject & Discipline | Multidisciplinary Academic Open Research |
| Categories | Science & Mathematics |
| Publication Year | 2004 |
| License / Rights | Open Access / Creative Commons |
| Resource Verification | Listed PDF (Verification Pending) |
| Original Host Website |
HAL Open Science
(hal.science)
|
| File Format | application/pdf (Portable Document Format) |
| Language | EN |
| Catalog ID | DOC-242664 |
| Original Source Link | Visit Source Page on hal.science » |