📖
Composites made of bioceramic and chitosan physical hydrogel as potential bone substitutes
Silvia Ramírez Caballero

Composites made of bioceramic and chitosan physical hydrogel as potential bone substitutes

Author / Organization:
Science & Mathematics Published 2018 Verification Pending

Overview & Synopsis

Bone substitutes, an approach to attend social demand for bone healing and reparation, are temporary replacements of bone tissue, promote bone formation and growth and finally are bioresorbed. No single material meets these requirements; an alternative is a bioinspired composite material. The objective of this thesis was thus to study the synthesis and properties of two bioceramics/biopolymer composites: chitosan physical hydrogels mineralized with apatite and hardystonite scaffolds impregnated with chitosan physical hydrogels. To obtain the first material, two strategies were developed. The first one consisted in the fabrication of chitosan physical hydrogels and its subsequent mineralization with apatite; the formation of micro-capillaries occurred under particular synthesis conditions, and apatite precipitates were found only on the surface of hydrogels. The second strategy consisted in a simultaneous conversion of chitosan-calcium phosphate suspensions into chitosan-apatite hydrogels. The suspensions were prepared by sequential or simultaneous mixing of calcium and phosphate suspensions with chitosan solutions. Smaller and more uniformly distributed mineral aggregates were formed following sequential mixing, attributed to higher homogeneity, lower viscosity and no-presence of chitosan. This enabled the use of these chitosan-calcium phosphate suspensions as inks for 3-D printing. In general, three factors impacted the mechanical properties of mineralized chitosan hydrogels: the base used for gelation (determining the gelation rate: a higher rate preserved chain entanglement, resulting in higher elasticity); the density of physical crosslinks (hence a higher storage modulus) and the ionic strength (that led to chitosan chain disentanglements, thus, low storage modulus). Chitosan hydrogels and mineralized hydrogels were not cytotoxic, having no deleterious effects on osteoblasts proliferation. To fabricate the second material, pre-ceramic ink was 3-D printed and then sintered to form crystalline hardystonite ceramic. Hardystonite scaffolds were impregnated with chitosan solution that was, next, converted to chitosan physical hydrogel. At higher chitosan concentration, viscosity of solution was higher and scaffold impregnation was lower. At higher gelation rate, which depend on base used for gelation, lower weight loss during gelation. Chitosan hydrogel partially filled the pores contributing to bearing of external loads and to energy dissipated by fracture.

Indexed from repository: HAL Open Science (hal.science)
Loading document from verified source...
Keyboard Shortcuts: ← / → for pages • + / - for zoom • 0 to fit width Powered by Mozilla PDF.js v3.11

Document Information

Document Title Composites made of bioceramic and chitosan physical hydrogel as potential bone substitutes
Author / Organization Silvia Ramírez Caballero
Subject & Discipline Multidisciplinary Academic Open Research
Categories Science & Mathematics
Publication Year 2018
License / Rights Open Access / Creative Commons
Resource Verification Listed PDF (Verification Pending)
Original Host Website HAL Open Science (hal.science)
File Format application/pdf (Portable Document Format)
Language EN
Catalog ID DOC-244930
Original Source Link Visit Source Page on hal.science »